Data elements that meet criteria using this datatype should document completion of the assessment indicated by the QDM category and its corresponding value set. Timing: The time the assessment is completed; Author dateTime.
Subject.Statement
DataType
The time the data element was entered into the clinical software. Note, some datatypes include both Relevant Time and Author dateTime attributes. The purpose is to accommodate Author dateTime if the actual start and stop times are not available when evaluating for feasibility, and also to allow specification of a time for Negation Rationale.
Indicates the reason that an action was not performed. Only QDM datatypes that represent actions (e.g., performed, recommended, communication, order, dispensed) allow the “negation rationale” attribute. The intent is to indicate a justification that such action did not happen as expected. This attribute specifically does not address the presence or absence of information in a clinical record (e.g., documented absence of allergies Vs lack of documentation about allergies). The syntax in the human readable HQMF is address in CQL examples and in the MAT User Guide. Prior versions of QDM used the syntax, “Procedure, Performed not done.” QDM 5.0 DRAFT uses the syntax, “Procedure, not Performed.” Note: Some datatypes include both Relevant Time and Author dateTime attributes. The purpose is to accommodate Author dateTime if the actual start and stop times are not available when evaluating for feasibility, and also to allow specification of a time for Negation Rationale.
The final consequences or data collected from the datatype. Results can be used in five ways, to express: That a result is present in the electronic record but any entry is acceptable. A numerical result is reported directly as a value. Values may be integers or decimal numbers without units, or as a quantity with a value and units – examples: 100 mg/dL for a lab test, 140 mmHg for blood pressure, as a percentage (actually a quantity with % as units), as a ratio (e.g., 1:4, 1:80). Beginning with QDM 5.3 measures use CQL logic to express the mathematical operators to constrain desired results to those above or below a certain threshold. A result that matches one of a specific set of coded concepts in a value set or a code that matches a direct referenced code. A result as a dateTime (Assessment, Performed and components).